1. Understanding ultrasound

用超聲波可以分為三種，即次聲波、聲波、超聲波。次聲波的頻率為20Hz以下；聲波的頻率為20Hz~20kHz；超聲波的頻率則為20kHz以上。其中的次聲波和超聲波一般人耳是聽不到的。超聲波由于頻率高、波長短，因而傳播的方向性好、穿透能力強，這也是為什么設計制作全自動超聲波清洗機機的原因。

Ultrasonic can be divided into three types: infrasound wave, sound wave and ultrasonic wave. The frequency of infrasound wave is below 20Hz; The frequency of sound wave is 20Hz ~ 20kHz; The frequency of ultrasonic wave is more than 20kHz. The infrasound wave and ultrasonic wave can not be heard by ordinary human ears. Due to high frequency and short wavelength, ultrasonic has good directionality and strong penetration ability, which is why the full-automatic ultrasonic cleaning machine is designed and manufactured.

2、超聲波如何完成清洗工作

2. How does ultrasonic cleaning work

全自動超聲波清洗機是利用超聲波在液體中的社會化作用、加速度作用及直進流作用對液體和污物直接、間接的作用，使污物層被分散、乳化、剝離而達到清洗目的。目前所用的全自動超聲波清洗機機中，空化作用和直進流作用應用得更多。

The full-automatic ultrasonic cleaning machine uses the socialization, acceleration and direct inflow of ultrasonic in the liquid to directly and indirectly affect the liquid and dirt, so that the dirt layer is dispersed, emulsified and stripped to achieve the purpose of cleaning. At present, in the full-automatic ultrasonic cleaning machine, cavitation and direct flow are more applied.

（1）空化作用：空化作用是超聲波以每秒兩萬次以上的壓縮力和減壓力交互性的高頻變換方式向液體進行透射。在減壓力作用時，液體中產生真空核群泡的現象，在壓縮力作用時，真空核群泡受壓力壓碎時產生強大的沖擊力，由此剝離被清洗物表面的污垢，從而達到精密洗凈目的。

(1) Cavitation: cavitation is the transmission of ultrasonic wave to liquid in the form of high-frequency transformation of compression force and pressure reduction interaction more than 20000 times per second. When the pressure is reduced, the phenomenon of vacuum nuclear bubbles is generated in the liquid. When the compression force is applied, the vacuum nuclear bubbles are crushed by pressure to produce a strong impact force, so as to peel off the dirt on the surface of the cleaned object, so as to achieve the purpose of precision cleaning.

（2）直進流作用：超聲波在液體中沿聲的傳播方向產生流動的現象稱為直進流。聲波強度在0.5W/cm2時，肉眼能看到直進流，垂直于振動面產生流動，流速約為10cm/s。通過此直進流使被清洗物表面的微油污垢被攪拌，污垢表面的清洗液也產生對流，溶解污物的溶解液與新液混合，使溶解速度加快，對污物的搬運起著很大的作用。

(2) Direct inflow: the phenomenon that ultrasonic wave flows along the propagation direction of sound in liquid is called direct inflow. When the sound wave intensity is 0.5w/cm2, the naked eye can see the direct inlet flow, which is perpendicular to the vibration surface, and the flow velocity is about 10cm / s. Through this direct inflow, the micro oil dirt on the surface of the cleaned object is stirred, and the cleaning solution on the dirt surface also generates convection. The dissolved solution of the dissolved dirt is mixed with the new solution to accelerate the dissolution speed, which plays a great role in the handling of the dirt.

（3）加速度：液體粒子推動產生的加速度。對于頻率較高的全自動超聲波清洗機機，空化作用很不顯著了，這時的清洗主要靠液體粒子超聲作用下的加速度撞擊粒子對污物進行超精密清洗。

(3) Acceleration: the acceleration caused by the pushing of liquid particles. For the full-automatic ultrasonic cleaning machine with high frequency, the cavitation effect is not significant. At this time, the cleaning mainly depends on the acceleration of liquid particles under the ultrasonic action to impact the particles for ultra precision cleaning.

3、全自動超聲波清洗機機的原理是什么

3. What is the principle of automatic ultrasonic cleaning machine

超聲波換能器將高頻振蕩電訊號轉換成高頻機械振蕩，以縱波的形式在清洗液中輻射。在輻射波擴張的半波期間，清洗液的致密性破壞并形成無數直徑為50-500μm的氣泡。這種氣泡中充滿著溶液蒸汽。在壓縮的半波期間，氣泡訊速閉合，會產生上百M(fèi)pa的局部液壓撞擊。這種現象稱為“空化”效應。在“空化”效應的連續作用下，工件表面或隱蔽處的污垢被爆裂、剝落。同時，在超聲的作用下，清洗液的滲透作用加強；脈動攪拌加??；溶解、分散和乳化加速；從而將工件徹底清洗干凈。

The ultrasonic transducer converts the high-frequency oscillation electrical signal into high-frequency mechanical oscillation and radiates in the cleaning solution in the form of longitudinal wave. During the half wave of radiation wave expansion, the compactness of the cleaning fluid is destroyed and numerous particles with a diameter of 50-500 are formed μ M bubbles. This bubble is filled with solution vapor. During the half wave of compression, the bubble velocity closes, resulting in a local hydraulic impact of hundreds of MPa. This phenomenon is called "cavitation" effect. Under the continuous action of "cavitation" effect, the dirt on the workpiece surface or hidden place is burst and peeled off. At the same time, the penetration of cleaning fluid is strengthened under the action of ultrasound; Pulsating stirring intensifies; Accelerated dissolution, dispersion and emulsification; So as to thoroughly clean the workpiece.

4、全自動超聲波清洗機機是由哪幾部分構成的

4. Which parts does the automatic ultrasonic cleaning machine consist of

超波清洗機主要由全自動超聲波清洗機槽和超聲波發生器兩部分構成。全自動超聲波清洗機槽用堅固彈性好、耐腐蝕的不銹鋼制成，底部安裝有超聲波換能器振子；超聲波發生器產生高頻高壓，通過電纜聯結線傳導給換能器，換能器與振動板一起產生高頻共振，從而使清洗槽中的溶劑受超聲波作用對污垢進行洗凈。

The ultra wave cleaning machine is mainly composed of a full-automatic ultrasonic cleaning machine tank and an ultrasonic generator. The tank of the full-automatic ultrasonic cleaning machine is made of strong, elastic and corrosion-resistant high-quality stainless steel, and the bottom is equipped with an ultrasonic transducer vibrator; The ultrasonic generator generates high frequency and high voltage, which is transmitted to the transducer through the cable connecting line. The transducer and the vibrating plate generate high frequency resonance together, so that the solvent in the cleaning tank can be cleaned by ultrasonic.

5、全自動超聲波清洗機機有什么特點

5. What are the characteristics of automatic ultrasonic cleaning machine

全自動超聲波清洗機與各種化學的、物理的、電化的和物化的清洗方法比較，具有以下獨特的優點：

Compared with various chemical, physical, electrochemical and physicochemical cleaning methods, the full-automatic ultrasonic cleaning machine has the following unique advantages:

·能快速、徹地工件表面上的各種污垢。

·It can quickly and thoroughly remove all kinds of dirt on the workpiece surface.

·能清洗帶有空腔、溝槽等形狀復雜的精密零件。

·It can clean precision parts with complex shapes such as cavities and grooves.

·對工件表面無損。

·No damage to the workpiece surface.

·可采用各種清洗劑。

·Various cleaning agents can be used.

·在室溫或適當加溫（60℃左右）即可進行清洗。

·It can be cleaned at room temperature or proper heating (about 60 ℃).

·整機一體化結構便于移動。

·The integrated structure of the whole machine is easy to move.

·節省溶劑、清潔紙、能源、工作場地和人工等。

·Save solvent, clean paper, energy, workplace and labor, etc.